Lioa battery charger

HOW TO USE LIOA BATTERY CHARGING MACHINE AS FOLLOWS:

- Step 1: Please plug the power plug into the power source

- Step 2: Clamp 01 + or - output to the battery terminal (Please note to clamp the correct + and - terminals). Why only clamp 01 + or - output and not both outputs is because when you Clamp both outputs to the battery, the turn-off voltage V-meter will always show the battery voltage as 12v or 6v depending on the battery voltage, so when adjusting the turn-off output voltage, it is very difficult and inaccurate if left alone. If the voltage is too low, there will not be enough charging current. If the voltage is too high, the charging current will be too large, leading to damage to the battery

- Step 3: Turn on the power switch in front of the LiOA battery charger

- Step 4: Adjust the 1-way output voltage with the knob in front of the machine so that the needle on the volt meter points to exactly 12V (thick black line on the meter) for charging a 12V battery or only to 6V (thick black line). on the meter) for 6V battery charging

- Step 5: Turn off the power switch in front of the LiOA battery charger

- Step 6: Clamp the remaining + or - output to the remaining battery terminal

- Step 7: Turn on the power switch in front of the machine at this time the machine begins to charge the battery, the current in meter A indicates the charging current being supplied to the battery. For batteries with a capacity of several dozen Ah such as 30ah, 45ah, 50ah.... 120ah, you can observe the charging current (When you observe the charging current gradually reduces according to the normal charging time, which is 4 hours). - 10 hours depending on battery capacity, charging current ~ 0V means the battery is fully charged and the device cuts off the charging current). For small capacity batteries such as charging motorbike batteries, it is only 4.5ah - 10ah.... due to the small charging current, you cannot see the charging current (In this case, when the battery is fully charged, you can usually touch it). feeling a bit hot in the battery case)

- Step 8: When the battery is fully charged, turn off the power switch in front of the machine so that the machine can rest and completely disconnect the output voltage.